2c Carmine Rose, Ty. II, Rotary Perf 11 x 10 (539). Top plate no. 7462 and "S20" block of four, three stamps Mint N.H., top left stamp single light hinge mark, small h.r. in selvage, radiant color, better centering than normally seen on the few multiples of this issue that exist, bottom right stamp tiny hole at top left

FINE CENTERING. AN EXCEEDINGLY RARE PLATE BLOCK OF THE 1919 2-CENT TYPE II ROTARY PRESS WASTE ISSUE. WE HAVE OFFERED APPROXIMATELY A HALF-DOZEN SINCE KEEPING COMPUTERIZED RECORDS, AND THIS IS THE ONLY ONE WHERE THE PERFORATIONS DO NOT TOUCH THE DESIGN. A REMARKABLE RARITY.

At the beginning or end of a coil-stamp print run from the 170-subject rotary plates, some leading or trailing paper was left over that was too short for rolling into 500-stamp rolls. In 1919 the Bureau devised an economical plan to salvage this waste by converting the leftovers from coil stamps into sheet stamps. This was accomplished by cutting the sheets into panes and running them through the flat-plate perforator for the horizontal perforations, giving the stamps perforations on all sides. The Type III design was far more plentiful (producing Scott 540) but a small number of Type II (Scott 539) was also produced.

Since Scott 539 was put through two different perforating machines (perforated 10 vertically on the rotary perforator during the coil part of production and then perforated 11 on the flat plate perforator), most of the stamps are off-center. The rotary press sheets also had a natural tendency to curl, making perforating on the flat plate perforator especially difficult.

A Power Search review located only four others (including a plate block of eight). All have perforations touching the design, and in three cases significantly so. The plate block offered here is graded Fine, but it is arguably Fine-Very Fine

Image Magnifier / Download

Power Search for Comparables